Exterior Lights

Break Lights

The tail lights from a previous owner was quite a mess, as seen below.

I was in NAPA the other day looking for some light bulbs and spied some LED lights that would fit in the hacked out holes IF I could come up with a way to make a good round hole.

I screwed on a piece of plywood to hold the position and with a 4-1/2" hole saw with great care drilled a new larger hole in the skin.

Took a bit of doing to get the rubber insert in the hole and a lot of persuasion to pop the lens in the last 1/2" way.

I used soapy water to get the last 1/2" in the screws only hold the lens cover to the rubber.

Marker Lights

The original running lights were in pretty tough shape.
It is a good thing I had access to the interior to cut off the fasteners on the rear lights. Carbon steel severely corroded. Front lights I was able to back out the screws with vise grips from the inside.